Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

11.06.2025 04:19

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

One is “what exactly is in a ‘surge protector’ ? ”

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

Scoop: Treasury officials defend "revenge tax" from wary GOP senators - Axios

(Dc diagram shown, AC is similar).

what exactly is a ‘surge’ protector?

For this case there are devices called Metal oxide varistors (MOV).

Why is Matt Gaetz being investigated but not Sarah (Tim) McBride? Why do we only care about grooming when it's the Republicans doing it?

It also is a device that limits the change in current flow.

What does a fuse do?

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

Can you give an example of a documentary where the person telling the story believed it to be true, but it turned out to be false?

a photo is worth a thousand words.

Edit 2024–10.

Upvotes:

Over-the-counter supplement could prevent heart disease in type 2 diabetes patients - Medical Xpress

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

These are simplified answers to the original question, and does not change anything I wrote above.

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

Sabrina Carpenter Shares New Song “Manchild”: Listen - Pitchfork

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

Here is a simplified AC power diagram.

Kohler's $51M Arizona award terminated by Department of Energy - ABC15 Arizona

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

nine

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

New Report Details Knicks’ Jalen Brunson Concern Before Firing Tom Thibodeau - Sports Illustrated

[image of Common-mode choke]

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

but I think this circuit , shows a few more pieces.

What do feminists mean when they say they want to ‘normalize’ menstruation and its discussion?

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

In schematic diagrams this is the symbol for a fuse:

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

Does the Lil Wayne song ‘Lollipop’ refers to a Lollipop sweet or a metaphor?

At least they know the answer if they wanted it.

It seems Mohan does not understand the difference between a comment and an Answer.

The bolt then partially travels down the line to your home.

Do dogs feel love?

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

Barnstars:

I post the exact comment here.

By skipping offseason workouts, Lamar Jackson forfeits another $750,000 - NBC Sports

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

This one hit behind the barn.

A fuse is a non-resetable over current circuit protector.

How has your life changed since starting college?

So, the voltage could go up to 500 volts, and the fuse will not open up.

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

This is 'the assistant's answer'

If sea levels were rising, wouldn't the acreage of coastal salt marshes increase? Are they?

These devices are installed between the “hot” and “neutral” and protective ground.

One

2024–10–16 [ OO OLAOYE OYEBODE ]

What are the major security challenges facing India, both domestically and internationally, and how does the government address them?

An AC voltage/ current source, and an ac inductive load.

2024–10–10[John johnson John Johnson ]

Now when you have a certain ac resistance, then a current flows in a loop.

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

This device then solves the entire problem.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

The MOV will conduct when the voltage exceeds 50% of line voltage.

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

But it can get overloaded, and no longer works.

First Sentence:

Can the fuse protect the electronic devices from lightning instead of a surge protector.

Because the load is inductive, the current lags the voltage.(by a bit).

so, what happens?

The third is lightning and “how it gets conducted into a home.”

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

but this device (an Inductor) … impedes the rapid changes in the current.

2024–10–14 [Omar Gharbi Omar Gharbi ]

This is where this question deviates from being a 'generic' question, and becomes more specific.

This is where the MOV conducts again, and dissipated the energy.

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

The other is “what does a “fuse” do?”

This is the picture of an electronic coil of wire wound around a core of magnetic material.

the problem then depends on "how fast does the fuse operate?".

What is lightning?

[old diagram got deleted by accident]

He then describes Rainy Season and Lightning.

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

He then describes the function of a fuse.

There are two important concepts here.

There are three different concepts here that are getting confused.

At one ohm, the resistor has a maximum of 1 watt power.

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

He then asserts :

But… the neutral is now “floating” because of the 1 ohm resistance.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

eight

A circuit breaker is similar, but is resettable.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”